Analysis Of Common Problems In Automatic Vacuum Packaging Machine

- Sep 17, 2018 -


Analysis of common problems in automatic vacuum packaging machine

Fully automatic vacuum packaging machine, reliable product quality, has a large number of customers in the country, is the ideal choice for you to buy automatic vacuum packaging machine.

With the continuous development of the society, the use of fully automatic vacuum packaging machines has basically run through all industries. From clothing, food and shelter to the development of industry and peasant industry, it has begun to inseparable from its appearance, but as long as it is a machine, there will be various problems. So today I will analyze with you the common problems of the automatic vacuum packaging machine and the solutions.

First, the vacuum is not enough or no vacuum

This problem is very simple. First, it may be that the bag is leaking and needs to be replaced with a new one. Secondly, there may be no vacuum in the heat-sealed air chamber when vacuum is applied, and it should be overhauled. Finally, it may be 1DT iron. The seal on the core gasket or the magnetic shield leaks, which can only be repaired or replaced;

Second, the vacuum packaging opportunity is not enough sealing strength

At this time, you should pay attention to it. First of all, you should check whether the temperature time adjustment is too low or too short. If it is, then re-adjust; secondly, is the vacuum time adjustment too short, the solution is to adjust it to be less than or equal to -0.08Mpa; If neither of the above is true, then it is necessary to see if the heat-sealed gas chamber is broken. If this is the case, then it will be replaced.

Third, the seal is not flat or corroded

 This is mainly due to temperature time problems, the solution is to re-adjust; or 2sj does not work, the solution is to re-adjust; repair or renew, if the heat seal delay is found to be too long, the power should be cut off in time.

 The above are just three problems that may occur during the use of the fully automatic vacuum packaging machine. However, in actual life, there will be various problems. At that time, special cases need special analysis, and the key to eliminate and solve the problem. It is the reason to find out the problem carefully, this is the root of the problem.